New Construction Installations
Load-calculated HVAC for new homes and additions, on the builder's schedule.
Gorman's Heating & Cooling installs complete heating and cooling systems in new construction throughout the Kansas City metro, for custom builders, spec homes and large additions. We work from the plans, hit the rough-in window, and come back for trim-out without needing to be chased.
Design comes first: a room-by-room load calculation, duct layout sized for the actual static pressure the system will see, adequate return air in every closed room, and equipment selected for the finished envelope rather than a rule of thumb per square foot. Getting this right in framing costs nothing; fixing it after drywall costs plenty.
Rough-in includes trunk and branch ductwork, properly supported boots and registers, bath and range venting, refrigerant line sets, condensate routing with a safe termination, gas piping to the appliance, and low-voltage runs to thermostat locations agreed in advance.
At trim-out we set and commission the equipment, balance airflow room by room, program the controls, register the warranties, and hand over documentation with the measured numbers. We coordinate with the electrician, plumber and framer directly so your schedule doesn't stall at our step.
- New home, addition, or full gut renovation
- Plans need a real load calculation, not a guess
- Builder schedule requires rough-in and trim-out on dates that hold
SIGNS IT'S TIME
New home, addition, or full gut renovation
Plans need a real load calculation, not a guess
Builder schedule requires rough-in and trim-out on dates that hold
TELL US WHAT IT'S DOING.
Describe the problem and we'll come look at it. For no heat or no cooling, call — it's faster.